The store will not work correctly in the case when cookies are disabled.
We use cookies to make your experience better.To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
A set of 6mm diameter (ID) hardened steel trapezoidal split sleeve dry pressing die set for pellet presses, ready for you to make 6mm diameter cylinder-shape pellets.
These die sets are professionally built for you to work with samples that tend to stick to the inner surface of the sleeve, trapezoidal split inner sleeves with pellet ejector make sample releasing a snap.
Die set includes
Four 6mm diameter cylinder-shape core dies made of highly polished hardened steel
One outer sleeve with trapezoidal inner wall
Three trapezoidal inner sleeves
One support plate
Two push rods
One pellet ejector
Important
Always wear protection goggles and gear during operation
Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
Never fill the die more than 2/3 its sleeve height with your sample and do not apply pressure beyond 4 tons. Across International is not responsible for any damage caused by misuse.
Four 6mm diameter cylinder-shape core dies made of highly polished hardened steel
One outer sleeve with trapezoidal inner wall
Three trapezoidal inner sleeves
One support plate
Two push rods
One pellet ejector
Important
Always wear protection goggles and gear during operation
Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
Never fill the die more than 2/3 its sleeve height with your sample and do not apply pressure beyond 4 tons. Across International is not responsible for any damage caused by misuse.
A set of 6mm diameter (ID) hardened steel trapezoidal split sleeve dry pressing die set for pellet presses, ready for you to make 6mm diameter cylinder-shape pellets.
These die sets are professionally built for you to work with samples that tend to stick to the inner surface of the sleeve, trapezoidal split inner sleeves with pellet ejector make sample releasing a snap.
Die set includes
Four 6mm diameter cylinder-shape core dies made of highly polished hardened steel
One outer sleeve with trapezoidal inner wall
Three trapezoidal inner sleeves
One support plate
Two push rods
One pellet ejector
Important
Always wear protection goggles and gear during operation
Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
Never fill the die more than 2/3 its sleeve height with your sample and do not apply pressure beyond 4 tons. Across International is not responsible for any damage caused by misuse.
