A set of 50mm diameter (ID) hardened steel dry pressing die set for pellet presses, ready for you to make 50mm diameter cylinder-shape pellets. Heating system with programmable digital temperature controller allows heating up to 250C.
Die set includes
Two 50mm ID cylinder-shape core dies made of highly polished hardened steel
One steel sleeve with PT-100 heater and sensor
One steel support plate
One thermal isolation plate
One push rod
One cylinder pellet ejector
One WK-1 digital temperature controller
Important
Always wear protection goggles during operation
Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
A set of 50mm diameter (ID) hardened steel dry pressing die set for pellet presses, ready for you to make 50mm diameter cylinder-shape pellets. Heating system with programmable digital temperature controller allows heating up to 250C.
Die set includes
Two 50mm ID cylinder-shape core dies made of highly polished hardened steel
One steel sleeve with PT-100 heater and sensor
One steel support plate
One thermal isolation plate
One push rod
One cylinder pellet ejector
One WK-1 digital temperature controller
Important
Always wear protection goggles during operation
Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
Never apply pressure beyond 200 tons
We use cookies to make your experience better.To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies.Privacy Policy.
