SKU
SDS50.H

50mm Diameter ID 250°C Heated Die w/ Digital Controller

Price $1,690.00

CUSTOMIZE YOUR PRODUCT

Wishlist

A set of 50mm diameter (ID) hardened steel dry pressing die set for pellet presses, ready for you to make 50mm diameter cylinder-shape pellets. Heating system with programmable digital temperature controller allows heating up to 250C.

 

Die set includes

  • Two 50mm ID cylinder-shape core dies made of highly polished hardened steel
  • One steel sleeve with PT-100 heater and sensor
  • One steel support plate
  • One thermal isolation plate
  • One push rod
  • One cylinder pellet ejector
  • One WK-1 digital temperature controller

 

Important

  • Always wear protection goggles during operation
  • Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
  • Never apply pressure beyond 200 tons
Specifications

Specifications

Electrical Requirements 110V 60Hz 550 watts
Maximum Pressure 200 tons
Maximum Temperature 250°C
Rockwell Hardness Rc 62
Diameter (ID) 50 mm
Sleeve Diameter (OD) 130 mm
Height 120 mm (assembled without sample)
Max. Load Height
28 mm
Temperature Step 1°C
Temperature Sampling 3 times per second
Accuracy +/- 1%
Working Environment 0-50°C, <35% RH humidity
Pressing Die Tolerance 0.01-0.02 mm (10-20 micron)
Material

Cr12 hardened carbon mold steel

 

Overview

A set of 50mm diameter (ID) hardened steel dry pressing die set for pellet presses, ready for you to make 50mm diameter cylinder-shape pellets. Heating system with programmable digital temperature controller allows heating up to 250C.

 

Die set includes

  • Two 50mm ID cylinder-shape core dies made of highly polished hardened steel
  • One steel sleeve with PT-100 heater and sensor
  • One steel support plate
  • One thermal isolation plate
  • One push rod
  • One cylinder pellet ejector
  • One WK-1 digital temperature controller

 

Important

  • Always wear protection goggles during operation
  • Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
  • Never apply pressure beyond 200 tons
Copyright © 2008-2023 Across International. All rights reserved.